Genuine DeWalt 760298-01 — small plastic glide/wear insert used where sliding parts or guards contact the saw. It’s a molded polymer sliding cap/insert that replaces a worn rubbing surface to restore smooth movement, reduce noise and protect assemblies. Typical inner/outer sizes listed for this insert are about D10 × d4 (≈10 mm outer diameter, 4 mm bore) and it’s supplied as a single replacement piece.

Example models this part is used on include DeWalt mitre/compound saws and related saws such as DWS773, DWS774, DWS777, DWS778 and DW700, DW701, DW876, DCS361. Use the model number on your tool to confirm fit, but these are the common applications reported for 760298-01.

Simple, low-cost replacement — installs in the existing holder/slot and brings worn sliding surfaces back to spec so the guard and sliding assemblies run quietly and smoothly again.