DeWalt BEARING THRUST - 153451-00
Original DeWalt 153451-00 — Thrust bearing designed for DeWalt mitre- and table-saw arbor assemblies. This small metal thrust bearing sits between the thrust washers and takes axial load from the arbor, reducing friction and wear on the gear / shaft stack so the blade runs true and the mechanism operates smoothly.
What you get: a genuine DeWalt thrust-bearing component (part no. 153451-00) made to the factory profile so it fits into the original bearing seat and works with the matching thrust washers. It’s supplied as the single bearing element used in the arbor/gear area and is intended to replace a worn, noisy, or grooved thrust surface.
Fits DeWalts Models : D27105 , D27107 , DCS727 , DCS781 , DHS780 , DW717 , DW718 , DW744 , DWS727 , DWS780
Quick notes for the repair-minded: the part is a direct-fit bearing that usually requires removal of the blade / guard and disassembly of the arbor / gearcase to access the thrust washers — basic hand tools or a small socket set are typically all that’s needed. Inspect the mating thrust washers and surrounding washers / seals while you’re in there and replace any that show wear.
If your saw’s parts diagram lists 153451-00, this original DeWalt thrust bearing will restore the correct axial support and stop the symptoms caused by a damaged thrust surface.
Compatible models this part will fit:
- DeWalt DW744
- DeWalt DW744XP
- DeWalt ETS744
- DeWalt ETS744
- DeWalt D27105
- DeWalt D27105 + V
- DeWalt D27107
- DeWalt D27107 - V
- DeWalt DW717
- DeWalt DW717XPS
- DeWalt DW718
- DeWalt DW718XPS
- DeWalt DWS780
- DeWalt D27107XPS
- DeWalt DHS790N MITER SAW STAND
- DeWalt DCS781N
- DeWalt DCS781B
- DeWalt DCS781X1
- DeWalt DW744S
- DeWalt DHS790AB
- DeWalt DW744XRS
- DeWalt DW744XRSCDN
- DeWalt DHS790T2
- DeWalt DCS361M1
- DeWalt DHS790AT2
- DeWalt DWS709
- DeWalt DW744XCDN
- DeWalt DCS727
- DeWalt DWS727
- DeWalt DW744SB
Showing first 30 compatible models. Contact us for full compatibility info.