Makita FAN 62 - 241815-8
Makita 241815-8 — Fan 62 (original Makita armature fan)
Get the original Makita Fan 62 (part no. 241815-8) — the small armature cooling fan that sits on the motor armature to keep the rotor and bearings cool under load. It’s the factory replacement fan used in the armature assembly for the Makita HP2010N 3/4" hammer drill.
Key details
- Part number: 241815-8; listed as “FAN 62” / “ARMATURE FAN 62”
- Function: armature-mounted cooling fan (installed on the armature/rotor, included as item in the armature assembly).
- Size reference: Makita labels this as “62” (fan size designation). That designation corresponds to a fan about 62 mm across. Note that final fit depends on the armature shaft and bearing arrangement, so confirm against your parts diagram.
Why this part
- Restores correct cooling airflow from the armature to protect the motor and bearings during use.
- Identical to the fan in the original armature assembly, so it installs and performs the same as the original part.
Simple replacement note
- This fan is normally fitted to the armature (it’s shown as the same item supplied with the armature assembly in Makita’s parts breakdown), so removal / installation is done when replacing the armature or servicing the rotor area.
If your parts diagram shows 241815-8 (Fan 62) for your model, this is the genuine Makita replacement to restore proper motor cooling and reliable operation.
Jump straight to the Makita spare parts diagrams:
Browse our full range of Makita drill parts. Makita hammer drill parts.
Compatible models this part will fit: