Makita 267101-9 — genuine Makita flat washer (listed as "Flat Washer 14"). A thin, flat metal washer used as the locating/retaining washer at the front of the bit sleeve / hammer-case assembly; sold as the single service part to restore proper spacing and spring seating in impact drivers.
This is the genuine Makita replacement washer shown in Makita parts diagrams for several impact driver models — for example TD001G, DTD172, GDT01 and older 6911D impact drivers — where it appears as the narrow flat washer that sits against the compression spring and bit sleeve. Use the part number 267101-9 when matching to your tool’s parts diagram to ensure an exact fit.
Simple to fit and intended to restore original clearances: if the retaining washer on your anvil/bit sleeve is missing, worn or deformed, replacing it with the original Makita 267101-9 brings the correct spacing and reliable bit engagement back to the tool.
Jump straight to the Makita spare parts diagrams:
Browse our full range of Makita impact driver parts. Makita hammer drill parts.
