If your Makita drill is not working, you’re not alone. This is one of the most common power tool problems, and in many cases it can be fixed quickly using the correct Makita spare parts rather than replacing the whole drill.
Whether your drill won’t turn on, keeps cutting out, or has suddenly stopped working, this guide explains the most common faults and the Makita replacement parts normally required to repair them.
When a Makita drill shows no signs of power, the fault is usually electrical.
Flat or faulty battery
Dirty or damaged battery terminals
Faulty trigger switch
Broken or loose internal wiring
Try a fully charged battery
Clean the battery contacts
Inspect the wiring inside the handle
Replace the trigger switch using the correct Makita spare part for your model
👉 Makita spare parts commonly needed:
Trigger switch, wiring loom, battery terminals
If your drill spins but struggles under load, the motor is not receiving full power.
Worn carbon brushes
Failing armature or field coil
Weak battery
Jammed or worn gearbox
Replace worn carbon brushes with genuine Makita replacement parts
Check the armature for signs of burning
Test with another battery
Clean and regrease the gearbox using Makita-approved grease
👉 Makita spare parts commonly needed:
Carbon brushes, armature, gearbox parts
If your Makita drill stopped working mid-job, this can point to overheating or component failure.
Thermal cut-out triggered
Burnt trigger switch
Shorted motor
Loose internal wiring
Allow the drill to cool down
Check the switch and motor for burning
Replace any damaged components using the correct Makita spare parts
An intermittent fault is a classic sign of worn brushes or a failing switch.
Works only when the trigger is held in a certain position
Cuts out randomly
Starts and stops
Replace the carbon brushes
Replace the trigger switch
Inspect and repair wiring connections
👉 Makita spare parts commonly needed:
Carbon brushes, trigger switch, wiring connectors
Sometimes the drill itself is fine and the problem is the battery or charger.
Battery charges correctly
Charger lights behave normally
Battery contacts are clean
Battery does not overheat
Replacing a battery is often cheaper than replacing the drill
👉 Makita spares commonly needed:
Batteries, chargers
Brushed Makita drills
These commonly fail due to worn carbon brushes, which are simple and inexpensive Makita spare parts to replace.
Brushless Makita drills
Faults are more likely caused by:
Electronic controller board
Hall sensors
Water or dust ingress
These models usually require specific Makita electronic spare parts rather than brushes.
Repairing your Makita drill using the correct Makita spare parts is:
✔ Cheaper than buying a new drill
✔ Better for the environment
✔ Keeps your existing batteries usable
✔ Faster when parts are in stock
Most Makita drill repairs involve replacing:
Trigger switches
Carbon brushes
Motors or armatures
Gearbox components
Batteries or chargers
Makita drills use model-specific parts, so always check the model number on your tool before ordering. Popular Makita drill models include:
DHP453
DHP484
DDF482
DHP458
DHP481
We stock a wide range of Makita parts including:
Trigger switches
Carbon brushes
Motors and armatures
Gearboxes and internal parts
Batteries and chargers
Using genuine Makita replacement parts helps ensure correct fit, safety and long-term reliability.
If your Makita drill is not working, it does not automatically mean it needs replacing. Many common faults can be repaired quickly using the correct Makita spare parts, whether that is a switch, set of brushes, or a replacement battery.
Diagnose the problem using the steps above and choose the right Makita replacement parts to get your drill back to full working order.
