Genuine Makita part 253196-8 — Flat washer (size "6") designed to restore correct spacing and load distribution on Makita power tools. This is the exact Makita flat washer used in factory parts diagrams (listed as "F. WASHER 6 / 253196-8").
What it is and why it matters
- Function: thin flat washer that sits under a bolt or nut to spread clamping load, keep components indexed, and prevent damage to mating surfaces.
- Intended bolt size: for M6 fasteners (commonly referenced as "Washer 6").
Typical dimensions (metric)
- Fits M6: inner diameter ≈ 6.4 mm, outer diameter ≈ 12 mm, thickness ≈ 1.4–1.6 mm — these are the standard dimensions for an M6 flat washer (DIN 125 / ISO 7089), which is the form factor Makita uses for its "Washer 6" parts. Use these metric specs to confirm fit in your assembly.
Example Makita models that use this part (examples, not exhaustive)
- HM1304B / HM1304 demolition hammers.
- Corded brush sander 9741 and drill 6310 (washer appears in those parts lists).
- Several Makita jigsaw models (example series DJV141/DJV142/DJV181/DJV182 and JV001G/JV002G families) and small saws (CS002G) where an M6 flat washer is shown in the parts breakdown.
Quick practical notes
- Use this genuine Makita washer when the original is worn, deformed, or missing to restore proper clamping and alignment.
- Confirm you need the M6 flat washer in your specific model by checking your tool’s parts breakdown or the fastener size at the installation point before fitting.
If you need to match it to an existing bolt: measure the bolt shank diameter (should be ~6 mm) and the clearance hole; the washer ID (~6.4 mm) should slide on but not be loose. Standard M6 washer OD (~12 mm) and thickness (~1.4–1.6 mm) are useful checks.
Jump straight to the Makita spare parts diagrams:
Browse our full range of Makita drill parts. Makita jigsaw parts. Makita hammer drill parts. Makita sander parts.
