Original Makita 256793-9 — "Pin 3" replacement pin, a small hardened alignment pin used inside the slide/magazine assembly. It’s listed as part number 256793-9 and described as the Pin 3 (3 mm) used to locate and retain internal linkages and the slide door on Makita cordless pin/brad nailers.
Fits several Makita nailer models, including DBN500, DPT353 and PT354D, and is also shown in parts lists for PT001G—useful when the slide door, pusher or lock lever needs a direct replacement.
Why this part matters: the pin keeps moving parts aligned so the driver and feed mechanisms operate smoothly — a worn or missing pin will allow play in the sliding parts and can cause misfeeds or jamming. This is an original Makita spare, so it matches the factory fit and tolerances you need when repairing a nailer. Makita parts are listed in the official diagrams under the same part number, so it installs directly where the factory pin was located.
Condition and use: single metal pin (listed as Pin 3 / 3 mm), sold individually; ideal if you’re replacing a lost or bent locating pin during a straightforward repair.
Jump straight to the Makita spare parts diagrams:
