Makita 261155-8 — Nylon Washer 24 (genuine Makita)

Keep your Makita impact driver running true with this original Makita 261155-8 nylon washer (listed as "NYLON WASHER 24"). It’s a molded nylon spacer/washer used in the hammer/anvil assembly to provide precise spacing, reduce metal‑on‑metal contact, and help the hammer mechanism cycle smoothly under high-impact loads. The part is specified by Makita as a "24" nylon washer in the DTD -series parts breakdowns.

Fits Makita Models : DTD154 / DTD170 and DTD148 — this washer appears in the exploded parts lists for those DTD models. Use it to replace a cracked, deformed or missing nylon spacer so the hammer/driver assembly will seat and operate correctly.

Notes for installation: this is a small molded nylon washer sized/numbered by Makita as "24" ; it restores the original spacing and isolating function in the hammer assembly and resists oil and light solvents better than plain plastic spacers. Install in the same orientation shown on your tool’s exploded diagram to retain correct clearances.

If you need a direct replacement that matches the factory specification for those DTD impact drivers, this genuine Makita 261155-8 is the correct part to restore fit and function.

Browse our full range of Makita impact driver parts. Makita hammer drill parts.